RED 3-AXIS LENS CONTROL SYSTEM - Manual (Page 37)

RED 3-AXIS SYSTEM OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0044, REV-D | 37
WIRED OPERATION
1. Connect the T.H.C. to the W.M.D. using the RED CAN Command Cable (provided).
2. Toggle the power switch to Cable mode.
The T.H.C. is now connected and ready for wired operation.
PAIR THE T.H.C.
Connect and pair the T.H.C. with your W.M.D. to operate in wireless mode. Once paired, the T.H.C. stores
wireless information for that W.M.D. and automatically reconnects when in range. The T.H.C. retains the MAC
address information for a single W.M.D.
1. Ensure the W.M.D. is receiving power.
2. Connect the T.H.C. to the W.M.D. using a RED CAN Command Cable.
3. Toggle the power switch to Cable mode.
The T.H.C. automatically pairs when the W.M.D. is on.
4. Install a RED LI BATTERY 7.2V.
5. Toggle the T.H.C. power switch to Battery mode.
6. Remove the RED CAN Command Cable.
The T.H.C. searches for the wireless connection. The wireless LED stops flashing and remains solid blue
when connected.
NOTE: The RED CAN Command Cable also provides power to the T.H.C. up to approximately 500 ft. When using
a cable longer than 500 ft, insert a battery and toggle the power switch to Battery to provide sufficient power.
The CAN cable will continue to support serial communication over a much longer distance.
NOTE: For more information, go to
“Configure Wireless Settings” on page 26 .
T.H.C. Wired Connection