RED 3-AXIS LENS CONTROL SYSTEM - Manual (Page 44)

COPYRIGHT © 2014 RED.COM, INC
RED 3-AXIS SYSTEM OPERATION GUIDE
955-0044, REV-D | 44
ConneCt tHe Lens ControL Motor
1. Connect a RED W.M.D. Motor Cable to the rotating connector on the Lens Control Motor.
2. Connect the opposite end of the RED W.M.D. Motor Cable to the corresponding lens function (Focus, Iris,
Zoom) 7-pin LEMO port on the W.M.D.
3. Retract the spring-loaded thumb latch to rotate the connector to the desired position.
4. Release the thumb latch and the rotating connector locks in place.
InstALL A Lens DrIVe GeAr
1. Insert the Lens Drive Gear mounting rod into the Lens Control Motor.
2. Twist the gear to align the guide pins.
3. Continue to apply light pressure, the gear magnetically snaps into place when properly aligned.
reMoVe A Lens DrIVe GeAr
1. Push on the gear axle to eject the gear from the Lens Control Motor.
Alternatively, grasp the Lens Drive Gear by the gear teeth and pull to disengage and remove the gear.
RED Lens Drive Gear M 0.8 Installed