RED 3-AXIS LENS CONTROL SYSTEM - Manual (Page 39)

RED 3-AXIS SYSTEM OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0044, REV-D | 39
SET A LENS LIMIT
The T.H.C. enables precision on-the-fly adjustments for lens functions.
1. Adjust the desired lens function knob/slider (Focus, Iris, or Zoom) to the min/max position.
(Example: zoomed out to capture full setting)
2. Press and hold the corresponding Limit button (Focus, Iris, or Zoom) on the T.H.C.
3. Adjust the corresponding lens function knob/slider (Focus, Iris, or Zoom) to the max/min position.
(Example: zoomed in on target)
4. Release the Limit button.
Press and release the corresponding Limit button to reinstate a previously set limit.
NOTE: The T.H.C. is a persistent state device, meaning that the lens limit will be maintained even if the unit is
powered down.
NOTE: When a lens limit button is held for three (3) seconds without a change made to the adjustment knob/
slider, the lens function limit will lock. For more information, go to “Set a Lens Lock” on page 40 .
REMOVE A LENS LIMIT
1. Press and release the corresponding Limit button.
The lens limit is now deactivated. The LED turns off to indicate that the lens limit is not set.
Press and release the Limit button again to reset the limit.
NOTE: Holding down the limit button for three (3) seconds without any change to any input locks the respec-
tive lens adjustment function on that T.H.C. unit. For more information, go to “Set a Lens Lock” on page
40 .
Hold Limit Button and Adjust