Tactic TTX650 6-Ch SLT Computer - Manual (Page 20)

20
Moving the control stick for the channel shown on-screen will change the position of the
vertical line in the graph. The point where the vertical line intersects the diagonal line is
shown at the bottom-left on the screen. The “x” (horizontal) coordinate is on the left, and
“y” (vertical) coordinate is on the right.
Repeat the above steps for the aileron, elevator, and rudder channels as desired.
CH5 AND CH6 SET
Enter this screen to set the functions of channels 5 and 6. At
the INPUT line select CH5 or CH6. Then follow the steps below.
Control: Choose which switch will control the selected channel. Switches are identifi ed
by letters A through H, as printed on the transmitter next to each switch.
On-screen the switches will be identifi ed as “SA” for switch
A, “SH” for switch H, and so on. All are 2-position switches
except switches “E” and “C” which have 3-positions. Defl ect
the switch which will ultimately control this function.
The display will show a graphic representing the switch,
and the different control positions of the switch as shown
here (0, 1, and 2). The default position for “0” will always
be in the up direction. The control positions of the switch
can be assigned to fi t personal preference. To use the
default settings, simply press ESC to confi rm. To change
the control locations of the switch to be high “H”, medium
“M”, or low “L” position, press or to move the cursor
to the position to be changed. Press ENTER to highlight
the function at this position. Then press
or to change
the control function. Repeat as necessary for all switch
positions. Press ESC when fi nished.
To remove the switch that has been set in the Control
function, press ENTER to highlight the switch selection
and press CLEAR.
Other functions in this radio allow for assigning a switch to a specifi c function. Refer
back to this section as needed.
Offset: Move the cursor to this function. Press ENTER, then or to fi nd the
percent to offset the center position of the channel shown on this screen.
CH5 AND CH6 SET
INPUT :CH5
CTRL :-----
OFFSET: 0%
TRAVEL:+100% +100%
CH5 AND CH6 SET
INPUT :CH5
CTRL :
OFFSET: 0%
TRAVEL:+100% +100%
L:(0)
M:(1) SC
H:(2)
CH5 AND CH6 SET
INPUT :CH5
CTRL :
OFFSET: 0%
TRAVEL:+100% +100%
L:(0)
SD
H:(1)