Tactic TTX650 6-Ch SLT Computer - Manual (Page 33)

33
To set points on the curve, start at the minimum throttle position
which will be noted as point “L”. A point for “L” is not marked
on the graph, but is the left-most end of the curve line. The
vertical position of this point can be adjusted by moving the
cursor to the RATE percentage, pressing ENTER and then
or as desired. Press ENTER when fi nished.
To set point 1 on the graph, advance the throttle stick until *
shows next to “Point”. Find the desired throttle stick position
and press ENTER. A + symbol will be placed on the curve
to mark this point.
Pressing or will adjust the vertical position of curve at this exact point. Adjust as
desired.
Repeat these steps to set points 2, 3, and 4 on the graph
as desired. A point for “H” is not marked on the graph, but is
the right-most end of the curve line. The vertical position of
this point can be adjusted by moving the cursor to the RATE
percentage, pressing ENTER and then or buttons.
Press ENTER when fi nished.
To clear any point on the graph, place the cursor on the RATE
percent, move the throttle stick until the graph’s vertical line
intersects the point, press ENTER and then CLEAR.
Any switch can be assigned to toggle between curves (Normal / Idle Up / Idle Up 2). Select
the switch on the CTRL line.
The exponential control of the user-defi ned throttle curve can
be active or inhibited. This will soften or make the transition
of the throttle curve smoother. Move the cursor next to the
EXPO line and toggle between “ACT” and “INH”. Press
ENTER when fi nished.
PITCH CURVE
The method for setting the pitch
curve is the same as for the throttle
curve as explained above, by
moving the throttle stick and using
the same controls within the pitch
curve screen.
THROTTLE CURVE
Point 1
RATE: +52%
CTRL:-----
EXPO: INH
+15%> +52%
THROTTLE CURVE
Point 4
RATE: +48%
CTRL:SD(0)
EXPO: INH
+81%> +48%
THROTTLE CURVE
Point 4
RATE: +48%
CTRL:SD(0)
EXPO: ACT
+81%> +48%
PITCH CURVE
Point L
RATE:-100%
CTRL:-----
EXPO: INH
-77%> -77%