Tactic TTX650 6-Ch SLT Computer - Manual (Page 29)

29
The “START/STOP” screen should show. Moving the stick
up or down will show changes to the “THROTTLE” position
value. The “START/STOP” value shows the trip point where
starting and stopping the timer will occur.
Move the stick to the desired position for the timer’s trip point
and press ENTER. The position value for START/STOP
should now match that for THROTTLE.
Press ESC to return the timer setting screen. The throttle
stick’s START/STOP position for the timer should show below
the timer settings.
For example, if a throttle stick START/STOP value of +45%
is selected, anytime the throttle stick is below this value the
timer will be stopped. Anytime the throttle stick is above this
value the timer will count. To reset the counter, move the
throttle stick below this value and press the CLEAR button.
The “Tx Batt.” timer at the bottom of the TIMER setting screen accumulates the total
amount of time the radio has been operational. This time can only be reset by moving
the cursor over “Tx Batt” and pressing the CLEAR button.
This menu is for setting servo control functions when helicopter
is the selected model type. Use of all functions in this menu
are the same as described on pages 13 –18 except that a
SWASH TYPE function screen is included for helicopters
instead of a WING TYPE function. Press ENTER for 2
seconds to access this menu from the home screen.
All channels for helicopters
are assigned as shown in
the chart.
SWASH TYPE
Enter this screen to select the type of swash plate in the helicopter. Setting this allows
for proper mixing of all controls for the main rotor. Four options are available, with some
offering cyclic and collective pitch mixes (CCPM) for optimum simplicity and performance.
It may be necessary to reverse the direction of a control when using a CCPM mix to
achieve the proper functionality.
Timer
TxBatt 08:13:10
START/STOP: +42%
THROTTLE : +42%
STO
Timer
TxBatt 08:13:23
: T1
START/STOP: +42%
01:00 C3
MODEL SETUP MENU – HELICOPTERS
MODEL SELECT
MODEL MANAGEMENT
SWASH TYPE
CHANNEL ASSIGNMENTS
WARNINGS
MODEL SETUP
Helicopters
CH1 AIL
CH2 ELEV
CH3 THRO
CH4 RUDD
CH5 GYRO
CH6 PITCH