Tactic TTX650 6-Ch SLT Computer - Manual (Page 35)

35
THROTTLE MIXER
This mix is used for non-heading hold gyros or when a heading hold gyro is in normal
mode. The helicopter’s throttle channel can be mixed to the tail (rudder) channel. This
mix can remain active at all times, or be controlled by selecting a switch on the CTRL
line. Move the cursor to select the rate to adjust, press ENTER and then
or to
adjust the value.
To reset any mix value or clear a switch selection, move the cursor to the value, press
ENTER, and then press CLEAR.
RUDDER MIXER
The aileron and/or elevator channels can be mixed to the rudder channel.
Setting of the rudder mix uses the same method as the throttle mix as explained above.
SWASH RING
Depending on how certain mixes are set and mechanical linkages are connected to the
swash plate, it’s possible that the mechanical connections can accidentally be damaged
or dislodged if they are forced to try and move past their own limitations. By adjusting
the maximum amount of travel the aileron and elevator channels can move the controls
away from center, this SWASH RING function can help prevent damage from occuring
to controls inside the model. At the default 150% setting the controls are not limited, and
effectively turns this function off.
Normal Switch Control
THRO->RUDD MIXING
Rudd
SP.0: 0%
CTRL:-----
THRO->RUDD MIXING
Rudd
SP.0: 0%
SP.1: 0%
SP.2: 0%
CTRL:SC(0)
Normal Switch Control
AILE->RUDD MIXING
Aile Elev
NORM: 0% 0%
CTRL:-----
AILE->RUDD MIXING
Aile Elev
SP.0: 0% 0%
SP.1: 0% 0%
SP.2: 0% 0%
CTRL:SE(0)