Tactic TTX650 6-Ch SLT Computer - Manual (Page 38)

38
3. Turn the teacher’s Tx off.
4. Pull the TTX650’s selected
trainer switch and hold it in
this position while turning
the power switch on. The
“searching” message should
show on-screen.
5. Move the student’s transmitter
to within 3 feet of the teacher’s
transmitter and turn on the
TTX404/600 power switch.
6. The TTX650’s “searching”
screen should disappear.
The teacher can release the
trainer switch. If the TTX650
doesn’t identify the signal
from the student’s radio a “NO
SIGNAL” message will show.
7. Once linked, move the throttle
stick on both transmitters to
minimum. Turn the Rx power on and make sure only those channels selected
for transfer to the student are transferred when the TTX650 selected trainer
switch is defl ected. Ensure the teacher can regain control of all channels when
the selected trainer switch is released.
8. Perform a complete range check before fl ight.
9. When the training session has ended, with the model safely landed and power
removed from the model, simply turn the power switch for both transmitters to
the OFF position. This will terminate the wireless link between both transmitters.
Teacher’s radio: Tactic TTX404/600 Student’s radio: Tactic TTX650
1. Link the teacher’s TTX404/600 to the Rx. Remove power from the model, and
then turn the teacher’s Tx off.
2. Pull the TTX404/600 trainer switch and hold it in this position and turn the power
switch on.
3. Move the student’s transmitter to within 3 feet of the teacher’s transmitter, turn
the power switch on and set the RF OUTPUT to ON.
4. The TTX404/600 LED should fl ash three times and then stay on to indicate the
bind was complete. Release the trainer switch.
5. Once linked, move the throttle stick on both transmitters to minimum. Turn the Rx
power on and make sure only those channels selected for transfer to the student
are transferred when the TTX650 trainer switch is defl ected. Ensure the teacher
can regain control of all channels when the trainer switch is released.
6. Perform a complete range check before fl ight.
7. When the training session has ended, with the model safely landed and power
removed from the model simply turn the power switch for both transmitters to the
OFF position. This will terminate the wireless link between both transmitters.
5.0V
>Axe100F 02
O OO
O OO SEARCHING
4.9V
>Axe100F 02
O OO
O OO
NO SIGNAL