Tactic TTX650 6-Ch SLT Computer - Manual (Page 25)

25
RUDDER MIXING
Mixing the rudder channel to the aileron and/or elevator channels can be very useful for
trimming an airplane to be neutral when using the rudder.
Select the rudder channel to mix to the aileron or elevator channels as needed. This mix
can be active at all times by not selecting a switch on the CTRL line. Or, for on/off control
of this mix select a control switch at the bottom of the screen.
FLAP MIXER
Normal Flap > Ail X
Flap > Ele X X
Flap > Flap X
Delta Flap > Ail
Flap > Flap X
1 Ail, 2 Ail,
Tail type Mixing 1 Ail 1 Flap 2 Ail 1 Flap
This function allows fl aps to be set, adjusted, and mixed to the ailerons and/or elevator
channels. Mixes such as fl aperons, air brake, and spoilers can be achieved in the
FLAPMIXER. These settings or mixes can be assigned and activated by a two or three
position switch. Not available for 1AI or 2AI wing types. Different setup options are
available depending on the selected wing type, where the fl aps can be mixed to the
aileron, elevator, or back to the fl aps.
Normal Switch Control
RUDD->AILE MIXING
Aile Elev
NORM: 0% 0%
CTRL:-----
RUDD->AILE MIXING
Aile Elev
SP.0: 0% 0%
SP.1: 0% 0%
SP.2: 0% 0%
CTRL:SE(0)
RUDD->ELEV MIXING
Aile Elev
SP.0: 0% 0%
SP.1: 0% 0%
SP.2: 0% 0%
CTRL:SE(1)