Tactic TTX650 6-Ch SLT Computer - Manual (Page 21)

21
Travel: To adjust the travel limits for a selected channel, defl ect the switch to one
position and adjust the maximum travel limit for this switch position, and then repeat
for the opposite switch position. Highlight either and press CLEAR to change back to
the default setting. Press ENTER when fi nished.
While the output channel is being operated normally, any movement of the input channel
will be mixed to – and also affect the movement of – the output channel.
THROTTLE CURVE
The throttle’s output is normally linear in relation to movement
of the throttle stick. A non-linear relation between the two – or
curve - can allow for optimum power control in certain models
or for specifi c types of fl ying styles.
Make sure the model’s full throttle position can be achieved
when the throttle stick is at maximum defl ection. The throttle
trim must be able to minimize throttle control completely when the throttle is at minimum.
Enter this function. Up to six points can be placed on the throttle curve, as designated
next to “Point” on the graph. Points L (low) and H (high) are each limited to a fi xed range
on the curve. Points 1, 2, 3, and 4 can be set if desired with respect to the position of
the throttle stick.
As the throttle stick is advanced note the point where the vertical line (throttle position)
intersects the diagonal line (curve). The coordinates of this point are shown at the bottom.
The “x” (horizontal) coordinate is on the left, and the “y” (vertical) coordinate on the right.
To set points on the curve, start at the minimum throttle position which will be noted as
point “L”. A point for “L” is not marked on the graph, but is the left-most end of the curve
line. The vertical position of this point can be adjusted by moving the cursor to the RATE
percentage. Press ENTER and then
or as desired. Press ENTER when fi nished.
To set point 1 on the graph, advance
the throttle stick until * shows next
to “Point”. Find the desired throttle
stick position and press ENTER. A
+ symbol will be placed on the curve
to mark this point.
THROTTLE CURVE
Point L
RATE: 0%
CTRL:-----
EXPO: INH
0%> 0%
THROTTLE CURVE
Point L
RATE: 0%
CTRL:-----
EXPO: INH
+12%> +12%
THROTTLE CURVE
Point L
RATE: +24%
CTRL:-----
EXPO: INH
+12%> +33%
THROTTLE CURVE
Point 1
RATE: +35%
CTRL:-----
EXPO: INH
+15%> +35%