Tactic TTX650 6-Ch SLT Computer - Manual (Page 27)

27
When the 2AI wing type is selected the brake can be mixed
to elevator and/or aileron. Adjust each mix percentage as
needed. Select a switch to turn the mix on/off.
When the 2AIL1FL wing type is
selected the brake can be mixed with
the elevator, aileron, or fl aps. Adjust
each mix percentage as needed.
Select a switch to turn the mix on/off.
PROGRAMMABLE MIXER
Up to four programmable mixes can be set, with one
channel being mixed to any one or more channels. Control
characteristics from the “input” channel will be passed to the
“output” channel(s), such as travel limits, exponential, etc. The
output channel will still be able to function independently as if it
were not mixed with another channel, but once an adjustment
is made to the input channel a resulting change will be seen
on the output channel as well. The mix level can be adjusted
by percent. A switch can be assigned to turn this mix on/off.
Enter the mixer screen. Move the cursor to select which mix to set and press ENTER.
The top line will show the mix number, with the cursor over
the input channel, and the output channel to the right. Press
ENTER and
or to highlight and set the input channel.
The rate of the input channel to mix with the output channel
can be adjusted for each the right and left side of the input
channel’s center position. With the cursor next to RATE L,
set the desired mix percentage. Repeat for RATE R. Note
the curve on the display’s graph will adjust according to the
percentages entered.
The amount of the input channel to be mixed can be offset by setting a percentage next
to “OFFSET”.
Assign a switch to control the mix in the CTRL line as explained earlier. Repeat the above
procedures for each of the four mixes that are to be confi gured.
AIR BRAKE SET
ELEV: 0%
AILE: 0%
CTRL:SE
AIR BRAKE SET
ELEV: 0%
AILE: 0%
FLAP: 0%
CTRL:SE
PROGRAMMABLE MIXER
Mix1: --->--- --INH
Mix2: --->--- --INH
Mix3: --->--- --INH
Mix4: --->--- --INH
Mix1:--->---
:
:
:
:
RATE L
R
OFFSET
CTRL
0%
0%
0%
INH