Tactic TTX650 6-Ch SLT Computer - Manual (Page 5)

5
Tactic’s custom SLT technology ensures that transmitters emit a strong, clear, frequency-
hopping 2.4GHz signal, and that your compatible receiver accepts no signal except yours.
Binding Tactic brand receivers is as simple as pushing a button,
which creates a locked-in, interference free link. The TTX650
radio can store up to 20 models in memory, making it perfect
to control a full fl eet of models with the super-affordable Tactic
brand 2.4GHz receivers. The TTX650 is also compatible with non-Tactic brand receivers
which use the *SLT protocol, for the ultimate in convenience and fl exibility.
* Make sure optional receivers have the genuine SLT protocol before use with the TTX650.
The TTX650 is also compatible with all transmitter-ready
aircraft bearing the “Tx-R” logo. Such aircraft include
receivers having the SLT protocol.
Always mount the optional receiver, servos, switch harness, battery, electronic speed
control, etc. as explained in the manual included with such equipment and/or the model.
Keep the Rx and its antenna(s) as far away from the engine/motor, servos, and ESC
and other electronic items as much as possible. It may also be a good idea to mount the
Rx inside certain models using Velcro,
® and wrap it in foam rubber to prevent damage
from strong vibrations or crash damage (except in extremely warm environments). It’s
best to have as few items surrounding the receiver’s antenna tips as possible inside the
model, to allow for the most obstruction-free signal path to the transmitter. Exposing the
receiver’s antenna tip outside the model is recommended if possible. For receivers with
two antennas, position the antennas at 90 degree angles with the tips resting at least 5
inches apart. If possible, allow one antenna to point vertically above the receiver itself.
INPUT POWER
Four 1.5V “AA” alkaline cells (included) or 1.2V “AA” NiCd or NiMH cells supply power to
the TTX650. Do not mix cell types, or old and new cells, etc. Slide open the battery door
to fi nd the four “AA” cell battery holder. Insert all cells with the proper polarity as shown
inside the battery holder. Carefully tuck the wires and battery holder inside the battery
compartment so not to damage them when closing the battery door.
Alternatively, an assembled 4.8V NiCd or NiMH “AA” fl at pack can be installed. Remove
the alkaline cell holder from the battery compartment and carefully observe the polarity
SLT TECHNOLOGY, Tx-R,
AND COMPATIBLE RECEIVERS
™
TM
RECEIVER INSTALLATION
TTX650 POWER SYSTEM