Lcd failure display, For lcd failure display, refer to – Toa VM-3000 Series User Manual
Page 60
60
F A U L T
E
1
A M P L I F I E R
< >
Indicates the point where the failure occurred.
The
red
number represents a variable part.
Indicates other failures that occurred before the displayed failure.
Use the [+] key to move the screen.
Indicates other failures that occurred after the displayed failure.
Use the [–] key to move the screen.
Indicates the occurrence of a failure.
Indicates the content of the failure.
F A U L T
V A
A M P L I F I E R
>
F A U L T
V A
A U D I O
L I N E
< >
F A U L T
V A
M I C R O P H O N E
<
F A U L T
V A
T A L K
S W
< >
F A U L T
V A
S E T T I N G
D A T A
>
F A U L T
V A
L O G
D A T A
>
F A U L T
V A
E M E R G E N C Y
S W
>
F A U L T
V A
P O W E R
< >
Failure Location: Voice Alarm System Amplifier (VM-3240VA or VM-3360VA)
The VM-3360VA or VM-3240VA has overheated or its fuse has
blown.
Failure detected in the VM-3360VA or VM-3240VA’s audio
lines.
Failure detected in the VM-3360VA or VM-3240VA’s front
panel-mounted emergency microphone.
Failure detected in the talk switch of the VM-3360VA or
VM-3240VA’s front panel-mounted emergency microphone.
Failure detected in the VM-3360VA or VM-3240VA’s set files.
Failure detected in the VM-3360VA or VM-3240VA’s log files.
F a i l u r e d e t e c t e d i n t h e V M - 3 3 6 0 V A o r V M - 3 2 4 0 V A ’ s
Emergency Activation switch.
Failure detected in the VM-3360VA or VM-3240VA’s power
supply.
10.6. LCD Failure Display
If a failure occurs, its information, including the failure point, is displayed on the VM-3360VA or VM-3240VA’s
front panel-mounted LCD screen.
In this event, the display alternates between "Failure information" and "BGM status." Pressing the OK key sets
the display to "Failure status."
The latest information is displayed on the LCD screen.
The ">" indication is displayed if failures occurred before the currently displayed failure, and the "<" indication
is displayed if failures occurred after the currently displayed failure.
To confirm other failures not displayed on the screen, move the display using the [+] or [–] key.