VACUUBRAND VACUU·CONTROL - Manual (Page 27)

Installation and connection
27 BA-N°: 999279/17.10.2014
4.3 Establishing initial connection
4.3.1 WLAN connection
The VACUU·CONTROL ® WLAN adapter is the wireless remote
interface to your CVC 3000. As delivered, the WLAN adapter acts
as SoftAP 2 and is therefore displayed as WLAN network. Con-
nect your end devices via WiFi directly to the CVC 3000.
Selecting WLAN network
1. Turn on the CVC 3000 that your WLAN adapter has been
connected to.
2. Switch on WLAN/WiFi at your end device.
5
Scan for available WiFi networks.
3. Wait until “VACUUCONTROL“ appears in the list of detected
WiFi networks.
IMPORTANT!
If your end device connects automatically to ano-
ther network,
> disconnect from this network,
> switch off „automatic WiFi ®
connection“ and
> select “VACUUCONTROL“ in the list of
available networks.
4. Select „VACUUCONTROL“ as network connection.
Depending on the end device, connecting may take some
time.
5 End device connected to WLAN adapter.
>
For further help  see chapter: “8.2 Troubleshooting
table”.
In case of a direct WiFi connection to your end device
no internet will be available. We therefore recommend
to integrate the WLAN adapter into your PC network, for
instance using a WLAN router.
 see chapter: “7 Network configuration and updates”
or ask your company’s IT department for support.
2 -> SoftAP = Soft Access Point; WLAN adapter acts as direct access point for
WLAN/WiFi devices.
Function
WLAN adapter