2 internal errors, 2 troubleshooting table, See chapter: “8.2 troubleshooting – VACUUBRAND VACUU·CONTROL User Manual
Page 68: Table, Resolving problems
Resolving problems
68
BA-N°: 999279/17.10.2014
8.1.2 Internal errors
Error messages that result from internal errors of the remote control are displayed
directly in the web browser.
Error messages shown on user interface (GUI)
Error message shown on user interface
3
Remedy
Controller is switched off!
`
3
switch on controller
You are using an outdated browser that is not
compatible with this software. Please try again
with a later browser version!
`
3
install the latest software version of the
web browser see “3.2 System require-
ments” chapter
Network configuration changed.
`
3
reload site
`
3
wait, consider booting time for WLAN
adapter
`
3
check network connection, select and
connect again.
CVC 3000 needs update to work properly with
VACUU•CONTROL™. Go to update page.
`
3
update CVC firmware,
see chapter “Updating CVC 3000 firm-
This controller is currently not supported.
`
3
contact our
, and ask for a list with
compatible devices
No communication with controller. Please check
settings.
`
3
connect controller
`
3
check baud value at controller (CVC/Con-
figuration/Baud = 19200)
`
3
check RS232 settings at CVC and if nec-
essary reset to factory settings
`
3
system administrator: reset
VACUU•CONTROL™ to factory settings
Update in progress. Please wait.
`
3
wait until update has finished
Connection interrupted! Please reload page.
`
3
reload page
JavaScript disabled.
`
3
enable JavaScript for your web browser
Update failed. Check file.
`
3
check update file or restart download
8.2 Troubleshooting table
Fault
`
Cause
3
Remedy
Personnel
Network out of
range.
`
`
WLAN signal impaired by
interfering signals.
`
`
Distance between WLAN
adapter and end device is
too far.
`
3
Do not place WLAN adapter
in the vicinity of sources of
electro-magnetic interference
`
3
In case of larger distances,
use a WLAN router to inte-
grate the WLAN adapter into
your network.
Admin