Winco DGC-500 - Manual (Page 5)

iv DGC-500 Introduction
Hardware Version
(Special Order P/N) Summary
D - 10/03
C
Implemented firmware version 2.04.XX and BESTCOMS version 1.03.XX
C - 09/03
C
Added reference to instruction manual on parts list
B - 07/03 C Implemented firmware version 2.03.XX and BESTCOMS version 1.02.XX
A - 06/03
C
Circuit board layout revised to improve manufacturing process
Manual Version Summary
D - 03/04
C
Added suitability and warning statements concerning compliance of part
numbers 9 3554 00 113 and 9 3554 00 114 with cURus Standard 1604.
C - 09/03
C
Added descriptions associated with new settings: CANBus Address,
Engine Stop/Start Configuration, and Genset’s kW Rating.
C
Added information pertaining to DGC Isolator Kits.
C
Added Volvo Penta EDC application information and diagrams.
C
Updated Pre-Alarm and Alarm information in Section 3, Functional
Description to include metric equivalents for settings.
B - 03/03
C
Revised style chart to show NFPA compliance as standard, J1939 support
as optional.
C Added coverage for part numbers 9 3554 00 111, 112, 113, and 114.
C
Added information about J1939 interface, ECU support, and state
machine operation where appropriate.
C Revised BESTCOMS section to accommodate new ECU settings.
C
Created new appendix of settings list with range for each setting.
A - 07/02 C Added instructions to Section 3, Functional Description for viewing
firmware version.
C
Revised the maximum setting of Sender Failure Alarm Time from 10
seconds to 30 seconds in Tables 3-1 and 3-2.
C
Replaced actual BESTCOMS version number in Figure 4-2 with generic
version number.
— - 02/02
C
Initial release