Winco DGC-500 - Manual (Page 67)

DGC-500-500 BESTCOMS Software 4-13
Figure 4-16. Settings Screen, Output Setup Tab
Programmable Input - Alarm/Pre-Alarm. Either of these check boxes can be selected to annunciate an alarm
or pre-alarm when the selected function triggers the programmable input. Alarm or pre-alarm annunciation
is available only when one the following functions are selected: Auxiliary Input, Battery Charger Fail, Fuel Leak
Detect, or Low Coolant Level.
Programmable Input - Auxiliary Input Label. This setting field is active only when Auxiliary Input is selected
as the programmable input function. An user-assigned label (eight characters, maximum) can be entered for
the corresponding programmable input.
Output Setup Tab
The Output Setup Tab settings of the Settings screen are shown in Figure 4-16. (Not all settings are visible
in the illustration.) Each tab setting is described in the following paragraphs.
The Output Setup tab consists of a list of pre-alarms, alarms, and conditions that can be assigned to close
either Programmable Output 1 or 2. An output selected by clicking the checkbox in the appropriate row and
column. The following pre-alarms, alarms, and conditions can be assigned to one of the two programmable
outputs.
C Battery Charger Failure Alarm
C Battery Charger Failure Pre-alarm
C
Battery Overvoltage Pre-alarm
C
Coolant Temperature Sender Failure Alarm
C Cooldown Timer Active
C
Emergency Stop Alarm
C
EPS Supplying Load
C Fuel Leak Alarm
C Fuel Leak Pre-alarm
C
Fuel Sender Failure Pre-alarm
C
High Coolant Temperature Pre-alarm
C High Coolant Temperature Alarm
C
Loss of Voltage Sender Failure Alarm
C
Low Battery Voltage Pre-alarm
C Low Coolant Level Pre-alarm
C
Low Coolant Level Alarm
C Low Coolant Temperature Pre-alarm
C Low Fuel Alarm
C
Low Fuel Pre-alarm
C
Low Oil Pressure Alarm
C Low Oil Pressure Pre-alarm
C
Speed Sender Failure Alarm
C
Oil Pressure Sender Failure Alarm
C Overcrank Alarm
C Overspeed Alarm
C
Pre-start Condition in Effect
C
Programmable Input 1 Closed
C Programmable Input 2 Closed
C
Programmable Input 3 Closed
C
Scheduled Maintenance Pre-alarm
C Switch Not in Auto
C
Weak Battery Voltage Pre-alarm