Winco DGC-500 - Manual (Page 94)

Parameter Setting Range
DGC-500 Appendix A-3
Low Fuel Level Alarm Threshold 0 - 100%
Low Fuel Level Pre-Alarm Enable On or Off
Low Fuel Level Pre-Alarm Level 10 - 100%
Low Oil Pressure Arming Delay 5 - 15 sec
Low Oil Pressure Pre-Alarm Enable On or Off
Low Oil Pressure Pre-Alarm Threshold 3 - 150 psi
Low Oil Pressure Alarm Enable On or Off
Low Oil Pressure Alarm Threshold 3 - 150 psi
Maintenance Interval Pre-Alarm Enable On or Off
Maintenance Interval Pre-Alarm Threshold 0 - 5,000 hrs
NFPA Level 0, 1, or 2
No-Load Cool-Down Delay 1 - 60 min
Number of Crank Cycles 1- 7
Number of Flywheel Teeth 50 - 500
Oil Pressure Sender Fail Alarm Off or On
Overspeed Alarm Delay 0 - 500 msec
Overspeed Alarm Enable On or Off
Overspeed Alarm Threshold 105 - 140%
Pre-Alarm Buzzer Enable Off or On
Pre-Crank Time Delay 0 - 30 sec
Pre-Start Contact after Disconnect Off or On
Rated Engine rpm 750 - 3,600
Sender Failure Alarm Time Delay 1 - 10 sec
Speed Signal Source MPU, Gen Freq, or MPU-Gen
Unit ID 1 - 247
Unit System English or Metric
Weak Battery Voltage Pre-Alarm Delay 1 - 10 sec
Weak Battery Voltage Pre-Alarm Enable On or Off
Weak Battery Voltage Pre-Alarm Threshold 4 - 8 Vdc or 8 - 16 Vdc