YSI 9600 - Manual (Page 112)

you acquired data every 15 minutes and you set the average interval to 60 minutes, each set of four
points will be averaged and then plotted as a single point. This feature will not only smooth a
graph, but will also reduce the amount of data exported. This is sometimes convenient when
exporting to a spreadsheet.
The x-axis parameter is normally Time, but you can choose any parameter you like. By default,
data files are sorted by increasing time. If you have chosen another parameter for the x-axis, then
you may want to have the data sorted before graphing it.
Change name
This command takes you to the Define Parameter Name dialog box where you may change the
default names of the parameters.
This dialog is intended to make changes like "degrees Celsius" to "degrees C". If you change
"degrees Celsius" to "degrees Fahrenheit", then the data displayed will be in degrees Celsius even
though the graph says "degrees Fahrenheit." To change the units for that parameter, use the
Change Parameter Units dialog box.
GRAPH
In the Setup menu, the Graph submenu has the following commands:
Font/Color
YSI Environmental 112 Model 9600 Nitrate Monitor