YSI 9600 - Manual (Page 26)

eyebolts attached to it. The picture on the left below shows the correct orientation; the one on the
right shows the incorrect placement of the carousel within the outer shell.
CAUTION: Make certain that no sections of tubing are pinched between the outer shell and the
carousel during the assembly process.
Correct Incorrect
• With the carousel supported by the outer shell and the top plate slots aligned with the outer shell strips,
press down on the top plate until the outer shell is seated in the circular slot on the carousel top plate
and the four (4) side screw holes in the strips on the outer shell are aligned properly with the holes in
the top plate.
• Install the four screws that were set aside in the disassembly process described in Section 2.1 above.
Use either a standard Phillips head screwdriver for this process or a battery powered driver with a
Phillips bit.
CAUTION: If a power driver is used, make sure that it is on a minimal torque setting to avoid
overtightening the screws.
CAUTION: The eyebolts which are used to attach the bail to the top of the carousel are DESIGNED
TO BE AT AN ANGLE as shown in the picture below. Do NOT attempt to straighten the alignment
of the eyebolts.
DO NOT CHANGE ALIGNMENT
OF EYEBOLTS
YSI Environmental 26 Model 9600 Nitrate Monitor