YSI 9600 - Manual (Page 33)

Clicking on the System selection in the top menu bar and then choosing the Select entry will display the
following screen that allows you to set up several items for later use.
Before proceeding, you should enter the following information in the System menu:
• Select a designation for your 9600 and type it in under Unit ID. This entry must be 15 characters or
less.
• Select an SDI12 address for your unit if you are going to use it with a data collection platform. YSI
recommends leaving the value at the default of zero (0) unless you have a specific reason to change it.
• Enter the date format by clicking on the arrow and selecting the preferred format.
• In time, you will be able to select from a variety of languages for the NUview menus. At the time of
release, however, only English is available, so no choice is possible for this item.
The “Board Info” data at the bottom of the display cannot be changed by the user and shows the current
versions of firmware in the two circuit boards that are present in the 9600.
Clicking on the Help|About selection in the top menu bar will display the following screen and will allow
you to ascertain the current version of NUview software on your PC.
Now proceed to Section 4 of the manual where you will begin a 9600 deployment.
YSI Environmental 33 Model 9600 Nitrate Monitor