Iwsehtimg bobbin into bobbin case, Insert the bobbin case into the shuttle – SINGER W ET 10 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
la...... . " ■ '. •
IWSEHTIMG BOBBIN INTO BOBBIN CASE
1
. Insert the bobbin into the bobbin case with
the thread running clockwise.
2. Pull the thread through the slit in the
bobbin case.
3 a. Pull the thread underneath the flat
tension spring. It will click when it is in
place.
b- Pull about
6
” (15 cm) of the thread from
the bobbin case, to be used later.
INSERT THE BOBBIN CASE INTO THE SHUTTLE
1. -Hold the latch open, with the locating pin
straight up.
2.
Slide the bobbin case onto the centre
spindle of the shuttle, keeping the thread
towards you.
NOTE; Be sure the locating pin fits into
the locating groove at the top of
the shuttle.
3. Release the latch to lock the bobbin case
in place.
10