Caring for the machine, Change the light bulb, Cleaning your machine – SINGER W ET 10 User Manual
Page 36: Cleaning feed dogs, Setting up your machine, Cleaning the machine
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. CARING FOR THE MACHINE
CHANGE THE LIGHT BULB
1. Unplug the machine.
2. a. Using the screw driver, push down the
lever located behind the presser bar and
the bulb will come out.
b. Push the lever to the right to lock.
3. a. Push up the bulb and turn slightly to the
b. Pull down to remove it.
4. a. Insert the new bulb and turn it with
some upward pressure until it stops.
b. Push up the bulb and turn to the right to
lock into place.
5. Push the lever back to the left and then up
into the machine.
CLEANING YOUR MACHINE
Remove mains plug before carrying out any
of the maintenance operations described
Your machine will offer years of household
sewing service, if you clean the machine
regularly, by just removing dusts and lints.
Note: Your machine is produced with the
quality components that are per
manently lubricated, so oiling is not
necessary under the normal use of
CLEANING FEED DOGS
Unplug the machine and remove the
Remove the needle plate with the large
3. Use the brush to remove the lint that may
have accumulated around the feed dogs
and in the shuttle area.