Inserting bobbin case into shuttle race, Changing needle – SINGER W1766 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
INSERTING BOBBIN CASE INTO SHUTTLE RACE
1. Ensure needle is at its highest position.
Pulling thread to the front, open the
latch of bobbin case and hold it.
2. Holding latch open, place bobbin case
onto centre pin in shuttle and release
latch.
CHANGING NEEDLE
1
. Raise needle to its highest position.
2. Loosen needle clamp screw and re
move old needle.
3. With the flat side of the needle facing
away from you, insert needle as far up
as it will go.
4.
Tighten the needle clamp screw
securely.
Note:
At
the
first
sign
of
any
stitching
irregularity always change the needle for
a new gpod quality one.
- 8
Advertising