SINGER W3051 - Manual (Page 25)

o2<2.
The quilting attachment (Fig. 27) will enable you to sew evenly spaced
lines on padded fabrics without marking them in advance.
To attach the quilter to the presser bar of the machine, first pull long
curved bar out of horse-shoe shaped clamp. Place the clamp on the
presser bar above presser foot, and push the bar through holes in
clamp.
Adjust curved end of bar to desired distance from needle so that it
presses into fabric. Then tighten thumb screw to lock quilter attach­
ment into place. When sewing, quilter bar should follow preceding
line of stitching.
Zigzag stitch quilting is done the same as straight stitch quilting with
the zigzag stitch dial set for any desired width.
Fig. 27
3.3. SenuHif B^uuJU.
Remove regular presser foot from the machine and attach braiding foot,
as shown in Fig. 28. Thread braid through small hole at front of foot.
Adjust width of zigzag seam and length of stitch to obtain a covering of
the braid which appears most desirable for the material you are sewing.
Using needle thread of a contrasting color will enhance the beauty of
your braiding.
_ 2 4 —
Fig. 28