Emcmaa ¿a do, 2<5. quut quide & *^uumk sc^eiu, Quut quide & *^uumk sc^eiu – SINGER W3051 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2.5. eMcMAA ¿a do.
The hemmer foot can also be used for doing felling. Proceed in the
following manner :
1.
Lay two pieces of cloth one on top of the other with their RIGHT
sides facing each other. The right edge of the bottom piece must ex
tend about Vs inch beyond the right edge of the top piece. See fig. 30.
2.
Sew both pieces of cloth together, using the hemmer foot like a regular
presser foot. Use the right edge of long toe of hemmer foot to guide
the bottom piece of material, while the left edge of the same toe
serves as a guide for the top piece of material
Fig. 30 shows this detail.
3. Open and spread out material and put back on machine right side down
ward. Make sewn edges of material stand up.
4.
Fold over the edges to the left
and insert them into the scroll
of
the
hemmer
foot.
Sew
as
you would do ordinary hemming.
Use left edge of long toe of
hemmer
foot
as
guide,
having
original seam run alongside of it
(Fig. 3 1 ) .
<
2
<
5
.
QUUt Quide & *^Uumk Sc^eiu
This is an attachment designed as a guide for straight stitching
when making wide hems, deep tucks, or seam width which are
greater than presser foot allows. (Fig. 28)
It is attached to machine as illustrated...a very simple operation.
Fig. 32
26