Changing snap-on presser feet (b), (d), (j), (l), Changing screw-on presser feet (h), (g), Cambio de prénsatelas a tornillo (h), (g) – SINGER 7021 Merritt User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Changing snap-on
presser feet (B), (D),

(J), (L)

Your machine comes with the General

Purpose Presser Foot (B) already attached.

You can easily change to any one of the other
presser feet which snap onto a common

shank by following the directions below.

• Raise needle to its highest position by

turning hand wheel toward you.

• Raise presser foot using presser foot lifter

at back of machine.

• Push toe of presser foot (

1

) up, until it snaps

off the shank (

2

).

• Remove foot from machine.

Place new foot under centre of shank.

• Lower presser foot lifter, fitting shank over

presser foot pin (3).

• Don’t turn screw. Instead, push presser

foot screw (

4

) down, firmly until foot snaps

into place.

Changing screw-on

presser feet (H), (G)

Some special presser feet can be purchased
at your SINGER stockist which have built-
in shanks that can be replaced as follows:

• Raise needle and presser foot.

• Loosen presser foot screw (1) and remove

presser foot with shank (

2

), guiding it

toward you and to the right.

• To replace presser foot with shank, hook

shank around the presser bar and tighten
presser foot screw with the use of a coin.

Cambio del prénsatelas

de colocación instantá­

nea (B), (D), (J), (L)

Su máquina viene con el prénsatelas de uso
general (B). Puede fácilmente cambiar dicho
prénsatelas por otro bajo las siguientes
directrices.

• Eleve la aguja a su posición más alta,

girando el volante de mano hacia Vd.

• Suba el prénsatelas utilizando la palanca

elevadora situada detrás de la máquina.

• Presione el dedo dei prénsatelas (

1

) hacia

arriba, hasta que éste salga de su anclaje

(

2

).

• Quite el prénsatelas de la máquina.

• Coloque el nuevo prénsatelas debajo del

centro de su anclaje.

• Baje la palanca del prénsatelas colocando

el anclaje sobre el eje del prénsatelas (3).

• No gire el tornillo. En su lugar, presione

el tornillo (4) hacia abajo firmemente hasta

que encaje en su sitio.

Cambio de prénsatelas a

tornillo (H), (G)

Algunos prénsatelas especiales que se

pueden adquirir en su centro de costura

tienen el anclaje y pueden recambiarse como

sigue:

• Eleve la aguja y el prénsatelas.
• Afloje el tornillo (1) y quite el prénsatelas

(2), guiándolo hacia Vd. y a la derecha.

• Para sustituir el prénsatelas, enganche el

tronco alrededor de la barra prénsatelas
y ajuste el tornillo con una moneda.

12

Advertising
This manual is related to the following products: