Inserting a bobbin, Colocación de la bobina, Winding a bobbin – SINGER 7021 Merritt User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Inserting a bobbin

To insert a bobbin, follow the instructions
below:

• Raise presser foot.

• Turn hand wheel toward you until needle

is in its highest position.

• Open slide plate and remove empty bobbin.

1

. Pull 4" (

1

0cm) of thread from replacement

bobbin and insert bobbin into case, as

shown.

2. Holding bobbin in place, guide thread into

notch (

1

) and then down the slot to the

left and guide around into notch (

2

).

3. Draw several inches of thread diagonally

across the bobbin toward the back of the

machine.

4. While holding thread on outside, close the

slide plate, allowing thread to extend

through the slot between the slide plate
and needle plate.

• Follow directions for “Raising Bobbin

Thread” on page 24.

Colocación de la bobina

Para colocar la bobina, siga las siguientes
instrucciones:

• Suba el prénsatelas.

• Gire el volante hacia Vd. hasta que la aguja

se halle en su posición más elevada.

• Abra la plancha corredera y retire la bobina

vacia.

1

. Tire 10 cm. de hilo de la bobina de

recambio e insértela en su alojamiento
como se muestra.

2

. Sujetando la bobina, guíe el hilo por la

rendija (

1

) y posteriormente por la abertura

de la izquierda, guiándolo a la abertura

(

2

).

3. Tire de algunos cm. de hilo diagonalmente

a través de la bobina hacia la parte

posterior de la máquina.

Sujetando el hilo por fuera, cierre la
plancha corredera, permitiendo que el hilo
saiga entre la rendija de la plancha
corredera y la plancha de aguja.

Siga las instrucciones para “Extracción

del hilo de la bobina” de la Página 24.

20

Advertising
This manual is related to the following products: