Caring for your machine, Removing and replacing, Bobbin case – SINGER 7021 Merritt User Manual

Page 72: To remove bobbin case, To replace bobbin case, Cuidado de su máquina, Como quitar y poner la caja de bobina, Para quitar la caja de bobina, Para colocar la caja de bobina, Caring for \bur machine

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

9. CARING

FOR YOUR
MACHINE

Removing and replacing

bobbin case

Caution: Before cleaning or adjusting the
machine, remove plug from the socket outlet.

• Raise presser foot and needle.

• Open slide plate, remove bobbin and

remove needle plate (see instruction on

page 14).

To remove bobbin case

e With a small screwdriver, turn bobbin case

holder (1) to the rear as far as It will go.

e Lifting the left side of the bobbin case, slide

It out from machine.

To replace bobbin case

e Guide forked end (2) of bobbin case under

feed (3).

Draw rim of bobbin case under position

plate (4). Be sure bobbin case is freely
seated on hook race.

e Turn bobbin case holder (

1

) forward as far

as it will go, locking bobbin case in place.

Note: Turn handwheel towards you to check

to make sure it is properly replaced.

Replace needle plate (see instruction on

page 14).

Insert bobbin and close slide plate.

9. CUIDADO DE

SU MÁQUINA

Como quitar y poner la

caja de bobina

Precaución: Antes de limpiar o ajustar la
máquina, desconecte el enchufe.

• Eleve el prénsatelas y la aguja.

• Abra la plancha corredera, quite la bobina

y la plancha de aguja (ver instrucciones
en la página 14).

Para quitar la caja de bobina

• Con un destornillador pequeño, gire el

sujetador de la caja de bobina (

1

) hacia

atrás hasta su tope máximo.

• Saque la caja de bobina, levantándola por

su lado izquierdo.

Para colocar la caja de

bobina

e Guíe el extremo ahorquillado (

2

) de la caja

de bobina por debajo del arrastre (3).

• Lleve la pestaña de la caja de bobina por de

bayo de la plancha corredera (4). Gire el volante
de mano hacia Vd. hasta que la caja de bobi­
na se aloje en su sitio.

• Gire la palanca (1) hacia adelante hasta

su tope, bloqueando la caja de bobina en
su sitio.

Nota: Gire el volante hacia Vd. para asegu­
rarse de que está debidamente colocada.

• Para poner la plancha de aguja (ver

instrucciones en la página 14).

• Inserte la bobina y cierre la plancha

corredera.

70

Advertising
This manual is related to the following products: