Starting a seam, Guiding and supporting fabric, Sewing in reverse – SINGER 7021 Merritt User Manual

Page 34: Comienzo de una costura, Guía y ayuda del tejido, Costura reversible

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Starting a seam

Place fabric under presser foot 1 /2 inch (12
mm) from rear of fabric. Align the right edge
with one of the seam guidelines on the throat
plate. Lower the presser foot.

Backstitch to the edge of the fabric for
reinforcement by pushing in the reverse
button located in centre of the stitch length

dial. Hold button in until stitching reaches
edge of fabric.

Release push button for forward stitching.

Guiding and supporting

fabric

Most fabrics need only to be guided in front

of the presser foot. Some fabrics, however,

require support while being stitched.

For tricot, and other similar synthetic knits,

apply gentle tension by holding the fabric
at the front and back of presser foot as
you sew. Do not pull fabric.

For elasticated fabric, stretch lace, and
knits with an unusual amount of elasticity,

hold the fabric firmly In front and back of

the presser foot to stretch the seam as the

stitches are being placed.

Sewing in reverse

To neaten the end of a seam, push in the

reverse button and backstitch 3>4 stitches.
Raise needle and presser foot and remove

fabric by drawing It to the back and left. Cut

thread on thread cutter on presser bar.

Comienzo de una costura

Coloque el tejido debajo del prénsatelas a

12 mm. del fondo del tejido. Alinee el borde

derecho con una de las líneas-guías de la

costura de la plancha de aguja. Baje el
prénsatelas.

Pulsando el botón de costura reversible
situado en el centro del dial de largo de
puntadas, cosa hacia atrás hasta el fondo

del tejido para reforzar la costura.

Mantenga el botón presionado hasta que las
puntadas lleguen al fondo del tejido. Suelte

el botón para coser hacia adelante.

Guía y ayuda del tejido

La mayoría de los tejidos sólamente nece­

sitan ser dirigidos por delante del prénsa­

telas. Otros, sin embargo, precisan ayuda

mientras se cosen.

Para coser tricot y otros tejidos similares

de punto sintético, aplique una ligera

tensión agarrándolo por delante y por
detrás del prénsatelas para mantenerlo
tenso mientras cose. No tire del tejido.

Para tejidos elásticos, de encaje exten-

sible y de punto, con una cantidad de

elasticidad poco común, aplique una

tensión más firme por delante y por detrás
del prénsatelas, para estirar la costura

según se van aplicando las puntadas.

Costura reversible

Para reforzar el final de una costura, presione

el botón de costura reversible y de 3-4

puntadas hacia atrás.

Eleve la aguja y el prénsatelas y quite el tejido

tirando de este hacia atrás y a la izquierda.
Corte el hilo en el cortahilos de la barra

prénsatelas.

32

Advertising
This manual is related to the following products: