Changing the needle plate (a), (c), Attaching the feed cover (f), Removing the extension tabie – SINGER 7021 Merritt User Manual

Page 16: Cambio de la plancha de aguja (a), (c), Colocación de la plan­ cha cubre arrastre (f), Desmontaje base de extensión

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Changing the needle
plate (A), (C)

Your machine comes with the General

Purpose Needle Plate (A) attached. The

Straight Stitch Needle Plate (C) may be
purchased at your sewing centre and can
be attached as follows:
• Raise needle and presser foot.
• Open slide plate.
• Lift up needle plate from right corner and

slide out from under foot.

• To replace needle plate, slide It under pin

(

1

) and push it firmly to the left.

• Press down until it snaps Into place.

Attaching the feed
cover (F)

The feed cover is used to keep the feed from

moving the fabric when attaching a button,

darning or sewing free-motion embroidery.
To attach it, follow the directions below:
• Raise needle and presser foot.
• Open slide plate.
• Slide feed cover on top of needle plate,

pressing tabs (

1

) and (

2

) into holes.

• Close slide plate.
• To remove, open slide plate and lift front

edge of cover; pull it away.

Removing the extension

tabie

Free arm sewing makes it easier to sew hard-

to-reach areas.

To change machine for free arm sewing, lift
right edge (

1

) of extension table, slide it to

the left and off the machine.

To replace the extension table, slide it to the
right keeping it even with the free arm, until

the tabs on the right lock Into place.

14

Cambio de la plancha de

aguja (A), (C)

Su máquina vienen con la plancha de aguja
de uso general (A). La plancha de aguja para

costura recta (C) puede ser adquirida en su
centro de costura y se coloca de la siguiente
manera:

• Eleve la aguja y el prénsatelas.

« Abra la plancha corredera.

• Suba la plancha de aguja desde la esquina

de la derecha y quítela por debajo del
prénsatelas.

• Para colocarla, deslícela debajo del perno

(1) y presione hacia el lado Izquierdo.

• Presione hasta que encaje en su sitio.

Colocación de la plan­

cha cubre arrastre (F)

La plancha cubre arrastre se usa para aislar

el género de los dientes de arrastre, al zurcir
o bordar. Para colocarlo haga lo siguiente:
• Eleve la aguja y el prénsatelas.
• Abra la plancha corredera.
• Deslice la plancha cubre arrastre sobre

la parte superior de la plancha de aguja
presionando los pivotes (

1

), (

2

) sobre los

agujeros.

• Cierre la plancha corredera.
• Para quitarla, abra la plancha corredera

y levante la plancha por su extremo y tire
de ella.

Desmontaje base de

extensión

La base libre permite coser en áreas de difícil

acceso.

Para disponer la máquina para este tipo de
costura, levante el borde de la derecha (

1

)

de la base, deslíceio hacia la izquierda y

retírelo.

Para volver a colocarlo, deslíceio hacía la

derecha, manteniéndolo al nivel del brazo

libre hasta llegar a su tope.

Advertising
This manual is related to the following products: