Placing bobbin case in shuttle – SINGER W167 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PLACING BOBBIN CASE IN SHUTTLE
Open hinged cover plate left of the needle.
See Fig. 1 ' Hold the bobbin case latch, D Fig.
9, between the thumb and forefinger of the left
hand, with at least three inches of thread running
from the top of the bobbin case to the right. Insert
and center the bobbin case on the stud of the shuttle
body, C'. Be sure
the
bobbin
case
finger, E ), will en
ter the shuttle race
notch, . A P r e s s
the bobbin case i B)
into the shuttle as
far as possilbe until
latch catches on the
center post of the
shuttle.
THEN release
D). Press bobbin case
again after latch has been released to make sure
the bobbin case is locked securely in place. Close
the cover plate.
Fig. 10
Fig. 9
the bobbin case latch.