SINGER 7184 - Manual (Page 17)

OPERATING THE MACHINE
With Electric Motor and Speed Controiier
Connecting machine
• Before plugging in your machine, be sure
the electrical information on the side of the
machine A, beiow the hand wheel agrees
with the range marked on your electrical
meter.
• Connect plug B to machine and plug C to
your socket outlet.
• To turn the machine and iight on (D) or
off (E), press switch as shown.
• To run the machine and controi speed,
press the speed controller F with your foot.
The harder you press, the faster the ma­
chine will sew.
DIS
CAUTION: Disconnect the power line plug from
the socket outlet when changing needles, feet
or needle plates or when leaving the machine
unattended. This eliminates the possibility of
starting the machine by accidentally pressing
the speed controller.
IMPORTANT
Machines for Great Britain and some other
countries having similar wiring standards
are shipped from the factory without a plug
for connection to the mains.
The wires in this mains lead are coloured in
accordance with the following code:
Blue - Neutral (N) Brown - Live (L)
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
If a 13 Amp. (BS 1363) plug is used a 3
Amp. fuse must be fitted, or if any other
type of plug is used a 5 Amp. fuse must be
fitted either in the plug or adaptor or at the
distribution board.
15