Applications with straight stitching – SINGER 7184 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Applications with straight stitching
DARNING
With Embroidery Hoop
• Needle Position: L • X: J.
• Stitch Width:
^ ^ ^
• Stitch Length: 0
• Needle Plato Raising Shim (with model! 7174)
• Snap-in Feed Cover (with model 7184)
• No Prosser Foot or Prosser Foot Shank
« Presser Bar; Lowered
. .. .
■
. .
• Insert needle plate raising shim as instruct
ed on page 11 (Snap-in Feed Cover with
7184 Model).
« Trim ragged edges from area to be darned
and centre worn section in embroidery hoop
designed for machine use.
• Position hoop under the needle and lowor
presser bar to engage tension. Hold needle
thread loosely with left hand, turn hand
wheel over and draw bobbin thread up
through fabric. Hold both thread ends and
lower needle into fabric. Take a few stitches
to secure.
Snip off thread ends close to fabric.
•
Outline
area
to
be
darned
with
straight
stitches for reinforcement.
• Stitch across opening, moving hoop under
needle at a slight angle from lower left to
upper right. Keep lines of stitching closely
spaced and even in length. When opening is
filled, cover area with crosswise lines of
stitching.
This method of controlling fabric movement
with an embroidery hoop may be used to do
embroidering or monogramming.
37