SINGER W431 - Manual (Page 13)

WINDING BOBBIN
Disengage the hand wheel (1) from
the stitching mechanism by turning
the clutch nut |2) toward you or-
counter-clockwise.
Place a spool of thread on one of
the spool pins and lead thread
through the Top Thread Guide
(3) and Bobbin Winder Tension
Disc at the right front of bedplate.
Run the end of thread through a
hole in the bobbin edge and place
bobbin on spindle of bobbin winder
fitting the notch on bobbin over
small pin on spindle.
Press bobbin winder latch (4)
down, and hold the thread end
loosely then start machine slowly,
and bobbin winder latch will be
released to stop winding when
bobbin is full.
Turn clutch nut away from you
until sewing mechanism is again
engaged so that needle moves when
you turn the hand wheel.
Break off loose thread end used to
start the winding and cut other
thread end. Then remove bobbin
from bobbin winder.
1 2