Binder, Folded binding, Two-tone binding – SINGER W431 User Manual
Page 45: Hand-cut bias binding
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BINDER
This attachment folds bias binding
and applies it to the edge of
material in one operation. Slots on
scroll of the binder are for corres
ponding
widths
of
commercially
folded bias binding.
The open mouth of binder scroll is
used for unfolded bias strips cut
15-16 inch wide.
FOLDED BINDING
Cut folded binding to a point,
insert in appropriate slot. Draw
through slot and under binder with
strong pin. Test stitching to be sure
it is on the edge. Adjust by sliding
binder to right or left.
TWO-TONE BINDING
Two bindings can be sewn on fabric
edge also in one operation. When
two are used always skip one size
between widths, inserting each in
correct size slot.
HAND-CUT BIAS BINDING
Cut 15-16 inch bias binding fold in
half for a couple of inches. Cut
binding
diagonally
toward
end,
almost to fold. Slip fold into center
of binder. Draw back until cut
opens and binding encircles open
end of scroll. Test stitching to be
sure it is on the edge, adjust if
necessary.
See suggestions on how to use the
binder. There are hundreds of other
44