Adjusting pressure on fabric and feed dog height, General sewing, Mending and darning – SINGER W431 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING PRESSURE ON FABRIC AND FEED DOG HEIGHT
• GENERAL SEWING
Usually for normal sewing, except for sewing on
very heavy and bulky fabrics and very stretchy
knit fabrics of medium and very light weight,
the center pin (B| of the pressure control be at
its lowest position also, the right button of feed
dog height control be pushed full down, except
for sewing on very sheer fabrics. For above
exceptional fabrics, refer to below table. To
reduce half the pressure, press the outer ring
(A) of the pressure control, then press the center
•pin (B) down again to halfway down. To reduce
half the feed dog height, push the left button
of feed dog height control slightly down to
raise right button up at a halfway position.
• MENDING AND DARNING:
In order to move the fabric freely in any direction for darning and mending, release
the center pin (B) completely by pressing down on the outer ring (A). Press down
the left button of feed dog height control all the way down, which drops the
feed dog well below the needle plate. To return the feed dog height to normal, push
the right button down in full position.