SINGER W431 - Manual (Page 44)

ATTACHMENT FOOT
In order to attach binder, edgestitcher and the
hemmers, it is necessary to remove the presser
foot and replace it with the attachment foot.
Mount binder, edgestitcher or hemmers by
sliding the attachment to the left as far as
possible and tightening the screw.
The mounting slot enables you to sew as close to
or as far away from the edge as desired. Just
move the attachment to the correct position
before tightening the mounting screw.
EDGESTITCHER
The edgestitcher is used in making dainty lace
insertions, edgings and piping.
The slots in the edgestitcher serve as guides in
sewing together various pieces of material. If you
want to sew lace, lace and embroidery, or lace
and tucked strips together, place the piece of
material that will be on top in slot 1 and the
lower fabric in slot 4. For instance, if you are
sewing lace edging to a finished edge of fabric,
place the fabric in slot 1 and the lace in slot 4.
Be sure to draw the lace and material under the
needle and back of the edgestitcher so that the
feed will carry it backward as you stitch. Hold
the fabric in the left hand and the lace in the
right, being sure the fabric overlaps the lace
slightly.
Rick-rack-stretch can be sewn to the edge of the
material in the same manner.
To trim with wide piping place the fabric in slot
4, and the fold of the piping to the left in solt 3,
for a narrow piping place fabric in slot 2 and the
folded edge of the piping to the right in slot 3.
Slot 5 may be used as a guide in stitching a
French seam.
43