SINGER 177 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Threading bobbin case

1. Hold the bobbin so that the thread will

unwind in the direction shown.

2. Place bobbin into the bobbin case.

3. Pull thread into notch, under the tension

spring and into the slot at the end of the

tension spring. Allow about three or four

inches of thread to hang from the bobbin

case.

Replacing bobbin case

1. Raise needle to its highest position.

2. Hold bobbin case by latch and place it on the

stud of the shuttle allowing position finger

to enter notch at top of shuttle body.

3. Release latch and press bobbin case in until

it clicks into place. Then close slide plate.

14

Advertising