SINGER 177 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Buttonholes (Continued)
Procedure
Place work under the presser foot, aligning
center marking of buttonhole with the needle.
Side stitching
Set stitch width selector at 2. Position the
needle in the fabric at point A. Lower the pres
ser foot and stitch down left side to end of
buttonhole marking, stopping at point B.
Leave
needle in fabric.
Raise presser foot and pivot
work on needle. Lower the foot and take one
stitch at same stitch width setting bringing
needle to point C.
Leave needle in fabric.
Bar tack
With needle in fabric, raise presser foot and set
stitch width selector at 4. Lower presser foot
and take approximately 6 stitches ending at
point D.
Leave needle in fabric.
44