Dodge 2008 Sprinter - Manual (Page 405)

403
Operation
Tires and wheels
4
̈ Make sure that on one axle just one
type of tire (same size, type con-
struction, load and speed rating) is
used.
Dual rear wheels:
̈ Rotate front tires by axle and the out-
er rear tire side to side if there is no
approved direction of rotation.
The tires used on dual wheel assem-
blies should be matched for wear to
prevent overloading one tire in a set.
̈ To check if tires are even, lay a
straight edge across all four tires.
For information on wheel change, see
the “Practical hints” section
( ୴ page 548).
! CAUTION
3500 dual rear tires have only one
approved direction of rotation. This is
to accommodate the asymmetrical
design (tread pattern) of the ON/OFF
road tire and the use of Outline White
Letter (OWL) tires.
When replacing a flat tire, the spare
tire may have to be remounted on the
rim or installed at a different location
to maintain the correct placement of
the tire on the wheel relative to the
tire/wheel position on the vehicle.
For example, if the spare is used to
replace an outer rear tire it will have
to remounted on the rim so that the
wheel is dished inward.
That way the tread design of asym-
metrical tires and the white writing of
the OWL tires will maintain proper
position.
nf_BA.book Page 403 Friday, January 25, 2008 3:53 PM