Dodge 2008 Sprinter - Manual (Page 552)

550
Practical hints
Flat tire
5
Hydraulic jack
̈ Assemble the three-part pump lever
for the jack.
1 Pressure release screw
̈ Close pressure release screw 1.
̈ To do this, turn the flattened section
on the pump lever clockwise to the
stop.
̈ Insert the pump lever into the recess
on the jack and secure it by turning it
clockwise.
̈ Make sure that the jack is positioned
vertically under the jacking points
described below.
̈ Raise the vehicle by pumping the le-
ver until the wheel is raised clear of
the ground.
Make sure that the distance between
the underside of the tires and the
ground does not exceed 1.2 in
(3 cm).
P58.10-2053-31
i
Never turn pressure release
screw 1 more than 1 or 2 full turns.
Hydraulic fluid could otherwise es-
cape.
nf_BA.book Page 550 Friday, January 25, 2008 3:53 PM