Dodge 2008 Sprinter - Manual (Page 567)

565
Practical hints
Flat tire
5
̈ Connect connector 6 to the 12 V
socket (12 V, 25 A, 300 watts) on
the center console (
୴ page 297).
̈ Start the engine (୴ page 186).
̈ Press I on electric air pump
switch 1.
The electric air pump is switched on.
The tire sealant is then pumped into
the tire and the tire pressure is in-
creased. Allow the electric air pump
to run for at least 10 minutes until
tire sealant bottle 8 is completely
empty and a minimum tire pressure
of 43.5 psi (3.0 bar) is achieved.
̈ Inflate the tire using the electric air
pump until the recommended tire
pressure (
୴ page 361) is achieved.
̈ Then press 0 on electric air pump
switch 1.
The electric air pump is switched off.
̈ Slide knob c quickly to the stop in
valve core extractor a.
! CAUTION
Do not connect the electric air pump
connector to the cigarette lighter
socket or another 12 V socket. These
are not designed for operating the
electric air pump.
! CAUTION
Do not run the electric air pump for
more than 20 minutes without a
break, otherwise it may overheat.
The air pump can be used again once
it has cooled down.
nf_BA.book Page 565 Friday, January 25, 2008 3:53 PM