3xLOGIC VIGIL Server - Manual (Page 141)

Test NTP Attempts to synchronize the time on the VIGIL Server system immediately.
View Report
Opens the Windows Event Viewer. Select the System log and look for an entry at the top of the list
with the Source “W32Time” to synchronize with.
Note: The NTP test will not record an event in the Windows Event log if the time is already correct.
Memory
Warning
Threshold
This setting monitors the memory usage of the VIGIL Server
process. Due to limitations in Windows there is a limit on the
amount of memory a single process can address. If the process
reaches the configured threshold, a warning will pop up indi-
cating that the memory usage is high. If this warning pops up
please contact your system administrator or support depart-
ment.
AUX Device
Settings…
Open the AUX Device Settings window for configuring other attached devices such as DIO boards and encoders.
Sub Stream
Settings…
On PROSERIES Cards, you can enable sub stream video
feed for analog video channels. Resolution, Quality, FPS
and Bitrate can be set. The Sub Stream will be available
to VIGIL Clients connected to the VIGIL Server.
Keyboard
Settings…
Allows you to add, edit, or remove a special camera control keyboard, such as the Pelco KBD300A.
Note: The Pelco KBD300A F1 and F2 buttons can be used to latch on and off VIGIL Server Relays #1 and #2.
3xLOGIC's VIGIL Server 7.1 User Guide
Pg. 137