3xLOGIC VIGIL Server - Manual (Page 87)

8.5 Video Loss Tab
If the video signal is lost from an enabled camera, you can specify an action to take in the Video Loss tab.
Video Loss Mode
Active Signal Detec-
tion
Enables hardware signal loss detection if the VIGIL Server capture card supports this feature.
Sensitivity Adjusts the sensitivity of the software signal loss detection.
Blank Camera
Detection
When enabled, the software detects a signal loss when the live video is all black or white. This is useful if
the camera is covered or blocked, and can be used in addition to or in place of hardware signal loss detec-
tion.
Record Blank Cam-
era
When enabled, the VIGIL Server continues recording the camera feed during a signal loss. The Record-
ing Mode for the camera must be set to Constant for this feature to work.
Video Loss Trigger
When enabled, Video Loss Detection triggers a DIO Relay.
Output Relay Select the DIO Relay.
Trigger
Select the type of trigger for the DIO Relay: Momentary, which lasts two seconds or Latched, which lasts
until the Video is recovered.
Video Loss Email Notification
When Enabled, an Email will be sent to the recipients configured in Email Settings... For details on how to set up Email
recipients See Section Video Motion Alarm Advanced Settings – Email Notification Settings.
3xLOGIC's VIGIL Server 7.1 User Guide
Pg. 83