ADLINK PCIe-7300A - Manual (Page 20)

10 Installation
2.2 Unpacking
Your cPCI/PCI/PCIe-7300A card contains sensitive electronic
components that can be easily damaged by static electricity.
The card should be placed on a grounded anti-static mat. The
operator should be wearing an anti-static wristband, grounded at
the same point as the anti-static mat.
Inspect the card module carton for obvious damage. Shipping and
handling may cause damage to your module. Be sure there are no
shipping and handling damages on the module before processing.
After opening the card module carton, extract the system module
and place it only on a grounded anti-static surface component side
up.
Again inspect the module for damage. Press down on all the sock-
eted IC's to make sure that they are properly seated. Do this only
with the module place on a firm flat surface.
Note: DO NOT APPLY POWER TO THE CARD IF IT HAS BEEN
DAMAGED.
You are now ready to install your cPCI/PCI/PCIe-7300A.
2.3 Device Installation for Windows Systems
Once Windows 98/2000/XP/Vista has started, the Plug and Play
function of Windows system will find the new NuDAQ/NuIPC
cards. If this is the first time to install NuDAQ/NuIPC cards in your
Windows system, you will be informed to input the device informa-
tion source. Please refer to the “Software Installation Guide” for
the steps of installing the device.
\\Manual\Software Package\SoftwareInstallationGuide