Desa DVF36TCR - Manual (Page 20)

www.desatech.com 112108-01C 20
INSTALLATION
Continued
Installing SKYTECH/WRC Model Remote
Control (Electronic Models Only)
1. Remove lower louver access panel in fire-
place (see step 1 of Wall Switch Installation,
page 18).
2. If a wall switch was installed, it must be
removed from ignition control circuit for
remote to work properly. Remove wire nuts
from switch connection at ignition control
module. Using wire nut, connect transformer
(blue) wire to remaining wire connected to
control terminal marked P.SW (see Figure
36, page 18).
3. The receiver does not require a battery. To
install, plug extension cord into one of the
outlet receptacles on the outlet box. Plug re-
ceiver unit into extension cord and the ignition
module into receiver unit (see Figure 37).
4. Replace louvered access panel by following
reverse steps on page 18.
5. Activate handset battery by removing insulat-
ing tab on back (see Figure 38).
OFF P
IL
O T ON
LO
HI
PI LOT
E A
16AI
7
TPTH
TP
TH
Gas
Valve
To Thermopile
Extension
Cord
Outlet Box
White
Red
Figure 37 - Installing Remote Receiver
(SKYTECH Model)
Optional Fan
Kit Plug
Receiver
Pull to Remove
Insulation Tab
Battery
Cover
12 Volt
Battery
Figure 38 - Installing Battery in Hand-
Held Remote Control Unit (SKYTECH)
GAS LINE HOOK-UP
WARNING: Before you pro-
ceed, make sure your gas supply
is OFF.
WARNING: Gas line hookup
should be done by your gas
supplier or a qualified service
person.
An equipment shutoff valve has been included in
the appliance’s gas supply system. You may con-
sider installing an extra gas shutoff valve outside
the appliance’s enclosure (check with local codes)
where it can be accessed more conveniently with a
key through a wall as shown in Figure 39.
Route a 1/2" NPT black iron gas line towards the
appliance coming in from the left. It is recom-
mended to route the pipe between the stand of
the firebox and the surround of the fireplace (see
Figure 40, page 21).
Figure 39 - Typical Exterior Wall Gas
Shutoff Installation
Key
Extension
Shutoff Valve
9-Volt Battery
Battery
Housing
Figure 36 - Installing Battery in Hand-
Held Remote Control Unit (HRC100)
Battery
Cover
Terminal
Wires
Remote Control Unit
Sensor
Tag