Operating fireplace, Electronic, Continued – Desa DVF36TCR User Manual

Page 27: For your safety read before lighting, Lighting instructions

Advertising
background image

www.desatech.com

112108-01C

2

OFF

P

IL

O

T

ON

LO

HI

PI

LOT

E

A

16AI

7

TPTH

TP

TH

Gas Control
Knob

Flame Adjustment
Knob

Position
Indicator

Figure 56 - Millivolt Control Valve

Figure 57 - Pilot

Thermopile

Pilot Burner

Piezo Ignitor

Thermocouple

6. Wait five (5) minutes to clear out any gas.

Then smell for gas, including near the floor.

if you smell gas, SToP! Follow “B” in the

safety information, page 28. if you don’t

smell gas, go to the next step.

7. Turn knob on gas control counterclockwise

to PiLoT.

8. Push in the control knob all the way and

hold in. immediately light the pilot by

pressing the ignitor button until a flame

appears 1 minute after the pilot is lit. The

pilot is located by the main burner. release

knob and it will pop back up. Pilot should

remain lit. if it goes out, repeat steps 5

through 8.

• if knob does not pop out when released,

stop and call gas supplier.

• if the pilot will not stay lit after several tries,

turn gas control knob to oFF and call your

service technician or gas supplier.

9. Turn gas control knob counterclockwise

to “N. Knob can be turned to oN

only if the control knob is popped out.

10. Set hi-Lo knob to desired setting.

11. Turn on all electric power to the appliance.

TO TURN OFF GAS

TO APPLIANCE

1. Turn off the wall switch.

2. Turn off all electric power to the appliance

if service is to be performed.

OPERATING FIREPLACE

Continued

3. remove control access panel.

4. Push in gas control knob slightly and turn

clockwise

to oFF. Do not force.

5. replace control access panel.

ELECTRONIC

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BeFore LiGhTiNG smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WhAT To Do iF YoU SMeLL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not

use any phone in your building.

• immediately call your gas supplier from

a neighbor’s phone. Follow the gas

supplier’s instructions.

• if you cannot reach your gas supplier, call

the fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. if the

knob will not push in or turn by hand, don’t

try to repair it, call a qualified service tech-

nician or gas supplier. Force or attempted

repair may result in a fire or explosion.

D. Do not use this appliance if any part has

been under water. immediately call a

qualified service technician to inspect the

appliance and to replace any part of the

control system and any gas control which

has been under water.

LIGHTING

INSTRUCTIONS

1. SToP! read the safety information before

proceeding.

2. Set thermostat to lowest setting (if appli-

cable).

3. Turn off wall switch.

4. open control access panel or louver.

Advertising
This manual is related to the following products: