Desa DVF36TCR - Manual (Page 22)

www.desatech.com 112108-01C 22
INSTALLATION
Continued
OFF P
IL
O
T
ON
LO
HI
PI LOT
E A
16AI
7
TPTH
TP
TH
Figure 41 - Millivolt Control Valve
Pilot
Adjustment Cap
ON/OFF
Knob
Outlet
Pressure
Inlet
Pressure
Pilot Gas Line
Do Not Kink To Pilot
Burner
To Main
Burner
Flame
Adjustment
Knob
E A
O
L
H I
L PI OT
To Main
Burner
Outlet
Pressure Inlet
Pressure
Flame
Adjustment
Knob
From
Gas
Supply
Figure 42 - Electronic Control Valve
INSTALLING LOG SET
Before proceeding, make sure the gas control valve
is in the OFF position. Logs have been shrink
wrapped on a cardboard backing to prevent break-
age during shipping. Cut around perimeter of each
log and pull gently on shrink-wrap to expose log.
Do not pull on log to release it from the shrink-
wrap as this may damage logs.
1. Remove lower louver access panel in fire-
place (see step 1 of Wall Switch Installation,
page 18).
2. Remove screen rod by sliding it either to the
left or right of fireplace until one of the rod
ends is free. Remove screen from fireplace.
3. To open glass door, undo latches located on
the top and bottom of firebox (see Figure
43). Note: Use caution when opening these
latches. Carefully open door by swinging it
to the left. The glass door is mounted to the
firebox with 5 screws.
4. Figure 44 shows the log set. Logs “A” have
a knot at the end of the log. Logs “B” have a
knot at the middle of the log. Twigs “C” have
the shape of a “Y”. Twigs “D” have the shape
of bent twigs. Twig “E” is a straight twig
which is placed across top of logs “B”.
Open
Close
Figure 43 - Opening Door Latches
Figure 44 - Log Set (9 Pieces)
A
A
B
B
C
C
D
D
E
Left
Front
Right
Back
Figure 45 - Burner and Grate (Top View)
Left
Right
Back
Front
Figure 46 - Installing Logs “A” (Top View)
5. Figure 45 shows top view of burner and
grate.
6. Place logs “A” as shown in Figure 46.
7. Place logs “B” as shown in Figure 47, page
23. Lift end of log “A” that will be propped up
and place log “B” under it. At the same time,
the other side of log “B” is placed over other
log “A”. Repeat procedure for other log “B”.