Exhaust and blower requirements, Bulk powder filtered system, Bulk powder filtered station – Labconco Bulk Powder Stations 3962622 User Manual

Page 11: Chapter 2: prerequisites

Advertising
background image

Chapter 2: Prerequisites

Product Service 1-800-522-7658

7

Exhaust and Blower Requirements

Bulk Powder Filtered System

The XPert Bulk Powder Filtered Balance System uses an integral motorized
impeller to draw room air past the operator and through the enclosure. This
contaminated air is then pulled through the rear perforated baffle and pushed
through the HEPA filter. The HEPA-filtered exhaust air is then forced out the top
of the enclosure. An optional carbon filter may be installed on the downstream side
of the HEPA filter located under the exhaust diffuser screen to protect against
nuisance odors.

The HEPA-filtered exhaust air can be re-circulated into the laboratory or exhausted
outside with the addition of the Thimble Exhaust Connection and remote blower
listed in Chapter 7.

Bulk Powder Filtered Station

The XPert Bulk Powder Filtered Balance Station does not include the motorized
impeller and must be exhausted to the outside by a remote blower. The remote
blower may be activated from the blower switch on the enclosure. See Electrical
Requirements in Chapter 2 and Electrical Supply Connections in Chapter 3. Only
one 10" dia. exhaust connection is required for the 5' and 6' XPert Filtered Balance
Stations to exhaust to the outside.

Data for the exhaust volume, noise pressure and enclosure static pressure loss is
listed for each filtered enclosure model at face velocities of 60, 80, and 100 fpm.

Proper blower selection may be determined from these exhaust requirements and
the total system static pressure loss. For outside exhaust, the enclosure must be
connected to either a dedicated blower or a house exhaust system.

Labconco offers accessory remote blowers listed in Chapter 7. Contact Labconco
for blower sizing assistance.

Enclosure
Width

Model Description

Face

Velocity

(fpm)

Exhaust

Volume

(CFM)

XPert Station

Initial Static

Pressure Loss with

HEPA Filter (in

H

2

O)

XPert System

Max.

Equivalent

Resistance of

10" Duct (ft)

XPert

System

Max.

External

Static

Pressure

XPert

System

Noise

Pressure

db(A)

5'

5' XPert Bulk Powder

Filtered Balance System

or Station

60
80

100

290
385
480

.38"-.46"
.55"-.67"
.72"-.85"

450
230
120

.22"
.20"
.15"

52-56
58-63
63-67

6'

6' XPert Bulk Powder

Filtered Balance System

or Station

60
80

100

350
465
580

.46"-.56"
.67"-.81"

.87"-1.03"

300
150

70

.20"
.18"
.13"

55-57
61-63
67-69

If the enclosure is connected directly to a house exhaust system, an adjustable
damper (or valve) must be installed to control the airflow properly. This is equally
important when a house exhaust system is controlling filtered enclosures. See
Chapter 7 for accessory Adjustable Damper ordering information.

Advertising